Pulse relay RIO-3-63
RIO-3-63 АС230V UHL4
|
2999.00 руб. с НДС
|
- 4 control inputs
- Through the zero conductor N for easy mounting
- 3 independent closed contacts
- Maximum switching current is 3x63A
- Input of static control (relay is on if on input is voltage) - allows to apply the relay as a three-phase contactor
- Input on/off - each pressing the button on this input changes the relay status to the opposite
- Input on
-
Input off
-
Possible to organize a joint control circuit with pulse relay RIO-1 and RIO-2
PURPOSE OF THE RELAY
Pulse relay RIO-3-63 is designed to distance remote on/off till 3 one-phase loads or one three-phase. It allows you to organize lighting control on the shop floor, in the warehouse, another large rooms, floor, etc. via the parallel connection buttons with backlight. Additional control inputs allow you to centrally switch on or off the load (lighting), depending on the set mode organize different lighting control circuit. The use of decoupling diodes (example module diodes MD-3) allows you to build multi-level lighting control circuit (similar to RIO-1 and RIO-2).
It can be used as a three-phase starter to turn on/off different three-phase loads.
Relay is produced in a plastic case with a unified front connection wires power and switched circuits. Mounting is carried out on a DIN rail width 35mm (GOST R IEC 60715-2003) or on a smooth surface. Terminal design provides robust clamp wires up to 2,5mm2. For convenience mounting three-phase cables is provided a transit bus (contact 10-10) for the zero conductor (not switched).
The relay does not require auxiliary power. Power is supplied from the control circuit.
WARNING: A position of contacts for supply can be arbitrary, starting at the first operation (OFF) state of the contact is restored.
A parameter
|
Unit
|
RIO-3-63
|
Supply voltage
|
V
|
АС160-250
|
Minimum time feed control signal, not less
|
s
|
0,3
|
Quantity button switches with indicator glow discharge with a current of 1mA at input "Y", not more |
pcs
|
20
|
Quantity button switches with indicator glow discharge with a current of 1mA at input "Y1", "Y2", not more
|
pcs
|
5
|
Delay relay, not more
|
s
|
0,25
|
Nominal/maximum switching voltage
|
V
|
250/400
|
Maximum switching current at each channel: AC250V 50Hz (AC1)/DC30V (DC1)
|
A
|
63
|
Maximum switching current (<4s at pulse duty factor 10)
|
A
|
100
|
Maximum load incandescent lamps
|
W
|
3х4000
|
Maximum switching power: АС250V 50Hz (АС1)/DC30V (DC1)
|
VA
|
3х15700
|
Minimum switching power (100V/5mA)
|
mW
|
500
|
Mechanical endurance, not less
|
cycles
|
5х105
|
Electrical endurance, not less
|
cycles
|
10000
|
Electrical strength (supply - contact) (50Hz - 1min)
|
V
|
АС2000
|
Maximum operating rate, not more
|
operations/h
|
500
|
Quantity and type of contacts
|
|
3 close
|
Operating temperature range
|
0C
|
-25…+55
|
Storage temperature
|
0C
|
-40...+70
|
Immunity to interference from bursts in accordance with GOST R 51317.4.4-99 (IEC/EN 61000-4-4) | level 3 (2V/5kHz) | |
Immunity to interference over voltage in accordance with GOST R 51317.4.5-99 (IEC/EN 61000-4-5) | level 3 (2kV A1-A2) | |
Climatic modification and placement category by GOST 15150-69 (non-condensing)
|
UHL4 or UHL2 | |
The degree's protection at case/terminals according to by GOST 14254-96
|
IP40/IP20 | |
The degree of pollution in accordance with GOST 9920-89
|
2 | |
Relative humidity of air
|
%
|
up to 80 (at 250С)
|
Operating position in space
|
|
artbitrary
|
Mode
|
|
round the clock
|
Dimensions
|
mm
|
105х63х94
|
Weight
|
kg
|
0,45
|
DIAGRAM OF OPERATING THE RELAY
When a control command is filed to the input «Y1» (On) contacts of the relay closes. When a control command is filed to the input «Y2» (Off) contacts opens. When a control command is filed to the input «Y» (On/Off) state of relay contacts is reversed.
When applying voltage to the A1 input - relay switches on, when removing the voltage - relay switch off, contacts open. |
CIRCUIT CONNECTION
Local and central control of several pulse relays
Local, central and multi-level control of several pulse relays (RIO-1, RIO-2 and RIO-3-63) performed identically (see the circuit connection RIO-1).
DIMENSIONS OF THE RELAY
Title
|
Order code
|
File to download
(manual)
|
File date
|
RIO-3-63 АС230V UHL4
|
4640016938926
|
v01.12.2015
|
English